ACOUSTIGRIP™ is an earphone cord management clip that attaches to the wires of your earphones. ACOUSTIGRIP™ is used to clip the earphone wires to a shirt or light weight jacket. This allows the consumer to perfectly set the wire slack so that the earphones do not tug on the ears with head movement or when the wire ‘swings’ during exercise activities. ACOUSTIGRIP™ can also act as a tether for earphones in the same way that “CROAKIES®” can be used to tether sunglasses. ACOUSTIGRIP™ is very small (smaller than a dime) so that it can remain attached on the wires and not get in the way. Three wire ‘receivers’ are provided to fit the most common wire sizes, such as those on the Apple earphones. The two wire receivers on the outside of the clip are for smaller wire pairs and the one wire receiver in the center can be used for a single larger wire. ACOUSTIGRIP™ clips are formed from a durable plastic material and can be readily “adjusted” with a coin and opened up if necessary to accept larger wire diameters.

TIP:



If your earphone wires are too large to fit into the space provided, use a dime to make the gap larger.